Canadian Hot Tub Retailers
More
Canadian Hot Tub Retailers

hot tub water manifolds

To replace a water manifold you will typically need to add in pieces of piping to allow for the section to be cut out. If you do not have the slack in the piping to make the glue joints bottom out, a leak may occur.


When gluing a manifold it is a good habit to connect the main in and out feed lines and position the manifold before gluing in the smaller discharge lines.


When the manifold has plug(s) to fill any unused ports, make sure to install the plugs first. It may be difficult to glue and install them after all the discharge lines are glued into place.

Water manifold with 6 outlets

Hot Tub Manifold Replacement from the Spa Guy

 This video is about The Spa Guy showing you how to replace a busted manifold on the bottom of an Artesian Hot Tub.. 

Copyright © 2024 Canadian Hot Tub Retailers - All Rights Reserved.

  • Privacy Policy
  • Acrylic Repair
  • Delivery Access
  • Site Selection
  • Site Preparation
  • Electrical Connection
  • General Troubleshooting
  • Centrex Repair
  • Winterizing
  • Spa Maintenance
  • Alberta
  • British Columbia
  • Manitoba
  • NW & Yukon Territory
  • New Brunswick
  • Newfoundland & Labrador
  • Nova Scotia
  • Nunavut
  • Ontario
  • Prince Edward Island
  • Quebec
  • Saskatchewan
  • Air Controls
  • Carbon Block Filters
  • Filtration
  • Fittings
  • Glue and Primer
  • Jets - Troubleshooting
  • Pumps – General
  • Pump Shaft Seals
  • Spa Pump Exploded View
  • Standard Components
  • Valves
  • Water Diverters
  • Water Fountains
  • Waterfalls
  • Water Manifolds
  • Spa Lighting
  • What is a Blower
  • Basic Chemical Safety
  • Start up chemicals
  • Chemical Maintenance
  • What is ozone
  • What are salt systems
  • What is UV

Powered by GoDaddy Website Builder